| Online Catalog | Fast Entry | Order History | Get Quote | View Cart | Logout |
|
Connector Wiring Instructions |
|
Parts Nomenclature |
|
|
Step 1. Cut and strip jacket to .28'' as shown.
|
 |
|
Step 2. Comb out braid and taper toward conductor.
|
 |
|
Step 3. Slide nut, washer and gasket over cable, then slide the clamp over the
braid so that its inner shoulder bottoms out against cable jacket end.
|
 |
|
Step 4. With clamp in place, comb braid back over clamp and trim to .09 from
the end. Trim dielectric to .13 leaving an exposed conductor length of .09. Do not
nick conductor. Wet conductor using a non acid core 60 - 40 tin lead solder.
|
 |
|
Step 5. slide contact pin on to conductor until it butts with dielectric, solder in
place using a 60 - 40 tin lead solder. Be sure to remove excess solder. Do not
overheat cable dielectric as swelling may prevent insertion of cable into shell.
|
 |
| Step 6. Slide cable into shell as far as it will go. Then slide nut into shell and screw in place with wrench until tight. Make sure to hold cable and shell rigid while rotating nut. |  |