| Online Catalog | Fast Entry | Order History | Get Quote | View Cart | Logout |
|
Connector Wiring Instructions |
|
|
|
|
|
Step 1. Slide nut, washer and gasket (with V groove toward cable end) over cable
jacket. Cut and strip cable jacket to .59
|
 |
|
Step 2. Comb out braid and taper toward conductor.
|
 |
|
Step 3. Slide clamp over braid (small end toward cable end) and push back
against cable jacket. Fold braid wires back over clamp and trim flush at large
end of clamp. Cut dielectric exposing .13 conductor length as shown. Do not
nick conductor. Wet exposed conductor using a non acid core 60 - 40 tin lead solder; do not overheat.
|
 |
|
Step 4. Slide contact on to conductor and solder in place using 60 - 40 tin lead
solder. Remove excess solder. Do not overheat cable dielectric as swelling
may prevent cable insertion into shell.
|
 |
|
Step 5. Slide cable assembly into shell as far as it will go. Then slide nut into shell
and screw in place with wrench until tight. Make sure to hold cable and shell
rigid while rotating nut. |
 |
