Step 1. Slide nut and gasket over cable jacket as shown. Cut and strip jacket
exposing braid by .27 length.
Step 2.comb out braid and taper forward towards conductor. Then slide
clamp over braid until it bottoms out on
cable jacket.
Step 3. fold braid wire back over clamp and trim as necessary so that they are
clear of clamp shoulder.
Step 4. cut and trim dielectric exposing conductor to .13 length. Do not nick
conductor. Wet conductor using a non acid core 60 - 40 tin lead solder. Do not
overheat.
Step 5. slide contact on to conductor and solder in place holding squarely against
dielectric. Remove excess solder. Do not
overheat cable dielectric as swelling may prevent insertion of cable into shell.
Step 6. slide cable assembly into shell as far as it will go. Slide nut into shell and
screw in place with wrench until tight (20-25 in/lb torque). Hold cable and shell
rigid while rotating nut.