| Online Catalog | Fast Entry | Order History | Get Quote | View Cart | Logout |
|
Connector Wiring Instructions |
|
|
|
|
|
Step 1. Slide grip sleeve over cable jacket. Cut and strip cable jacket, braid and
dielectric to dimensions shown. Make all cuts sharp and square. Do not nick
braid, dielectric or center conductor. Wet conductor using a non acid core
60 - 40 tin lead solder. Do not overheat. |
|
|
Step 2. Slightly flare braid as shown. Do not fray. Slide nut onto cable so that
stem slides under braid. Push until dielectric bottoms out inside nut.
|
 |
|
Step 3. Slide grip sleeve forward over braid and butt against nut. Remove all
slack in braid. Crimp grip sleeve with Thomas & Betts(1) crimp tool number
WT-200 while keeping cable dielectric bottomed out inside nut. Slide contact
onto pre wetted conductor and solder in place using non acid flux. Do not get solder on outside surface of contact. |
|
|
Step 4. Slide insulator over contact then slide cable assembly into shell. Screw
together using wrench, hold cable assembly stationary while rotating shell.
|
|
|
(1) Thomas & Betts Corp. 8155 T & B Blvd. Memphis TN 38125 Phone: 800-888-0211 |
 |
