| Online Catalog | Fast Entry | Order History | Get Quote | View Cart | Logout |
|
Connector Wiring Instructions |
|
|
|
|
|
Step 1. Slide nut, washer and gasket over cable. Cut off outside jacket to .94
dimension shown. Make a clean cut,
being very careful not to nick braid. Cut outer braid to .59 dimension as shown. |
|
|
Step 2. Slide first braid clamp over braid up to outer jacket. Fold first braid
back over clamp, making sure braid is
evenly distributed over the surface of clamp. Trim second jacket to .47 dimension
as shown. |
|
|
Step 3. Trim second braid to dimension .31 as shown. Slide on outer ground
washer, insulator and second braid
clamp over inner braid. |
|
|
Step 4. Fold second braid back over braid clamp, again making sure that
braid is evenly distributed over the surface
of the clamp. Trim inner dielectric to the .13 dimension as shown. |
|
|
Step 5. Tin the inside hole of the contact. Tin wire and insert into contact and solder.
Remove any excess solder. Be sure cable dielectric is not heated excessively
and swollen so as to prevent dielectric from entering the plug body.
|
 |
| Step 6. Place front insulator and inner plug body contact into back of plug body and push into proper place. Insert cable-contact assembly into plug body. Screw nut into body with wrench until moderately tight. | 
|
